The Aeroworks prox260 are in, who's getting one?
09-24-2010 | 01:30 PM
#26
Junior Member
Joined: Jul 2009
Posts: 15
Likes: 0
Received 0 Likes
on
0 Posts
From: West Hempstead, NY
RE: The Aeroworks prox260 are in, who's getting one?
What aleron servers did you guys use? I was going to put JR DS821's, but the heads don't seem to be sticking out the bottom of the wing enough for the control horn. Any ideas?
09-27-2010 | 01:05 PM
#28
Senior Member
Joined: Jun 2010
Posts: 187
Likes: 0
Received 0 Likes
on
0 Posts
From: Odessa,
WA
RE: The Aeroworks prox260 are in, who's getting one?
Now that I've built one I can see my advice above is totally wrong, since the servos go through the bottom of the wing ( of course) but are mounted to the top of the rails. Adding ply to these would only make the distance greater. There are thread all over this board about this plane. It would be cool if we all picked one so information would be easier to find. Just sayin'
09-27-2010 | 01:10 PM
#29
Thread Starter
Senior Member
My Feedback: (1)
Joined: Mar 2004
Posts: 2,690
Likes: 0
Received 0 Likes
on
0 Posts
From: Auburn,
WA
RE: The Aeroworks prox260 are in, who's getting one?
ORIGINAL: Dave45
There are thread all over this board about this plane. It would be cool if we all picked one so information would be easier to find. Just sayin'
There are thread all over this board about this plane. It would be cool if we all picked one so information would be easier to find. Just sayin'
09-28-2010 | 10:32 PM
#30
Senior Member
My Feedback: (10)
Joined: May 2002
Posts: 167
Likes: 0
Received 0 Likes
on
0 Posts
From: San Antonio, TX
RE: The Aeroworks prox260 are in, who's getting one?
Here are a couple videos of mine in action.
http://www.youtube.com/watch?v=Q8Csz...eature=channel
http://www.youtube.com/watch?v=z7vM2...eature=channel
http://www.youtube.com/watch?v=Q8Csz...eature=channel
http://www.youtube.com/watch?v=z7vM2...eature=channel
09-29-2010 | 10:08 AM
#31
Joined: Feb 2009
Posts: 723
Likes: 0
Received 0 Likes
on
0 Posts
From: Denver, CO
RE: The Aeroworks prox260 are in, who's getting one?
nice videos and great 3D flying. Which size do you like better, the 60 or 40? Also, do you think an OS95AX would be adequate in the 60 size?
