Was considering this airplane for my os GT33 for some 3D and pattern (in equal parts). Any one out there have this one?

http://www.aero-works.net/store/detail.aspx?ID=461

Ameyam

I think that would be a killer combo if kept close to 11 lbs.

Thanks, speedracerntrixie.

But what I really need is tips and tricks, suggestions, etc about the airplane- how it flies, where I need to reinforce and the general build quality

Ameyam

Anyone?

I think it is a fairly new model may not be much out there.

I received my AW Extra 300 30cc today. It not as 'spectacular' as everyone said it would be, but its nice and I do feel I should have taken the plunge earlier. What I liked most is that most of what I usually reinforce is already done for me, atleast what I can see without unpacking the fuse. Since there is stil some time before I put it together, I didnt open up everything, just checked that all parts were ok and got a general feel for the build- it does seem to have the wood in the right areas. May be I will do a unboxing and build thread like Goose here but that would be some time later. Thanking everyone for the advice

Ameyam