Lancair engine fit
10-02-2003 | 12:44 PM
#1
Thread Starter
My Feedback: (551)
Lancair engine fit
I'm assembling the GP Lancair with an OS 61FX and their recommended in-cowl muffler. Following the instructions exactly, I wind up with a 3/16" gap between the spinner and the front of the cowl. Has anyone else had this problem?
The spinner is also out of alignment with the boss on the front of the cowl. (Too high and off to the right.) Is this just my kit?
Jim
The spinner is also out of alignment with the boss on the front of the cowl. (Too high and off to the right.) Is this just my kit?
Jim
