Revenge of the SpaceWalker & YS 1.10 !
#1
Thread Starter
Join Date: Mar 2003
Location: Visalia, CA
Posts: 234
Likes: 0
Received 0 Likes
on
0 Posts
Revenge of the SpaceWalker & YS 1.10 !
Well,
I have almost finished rebuilding the Spacewalker ARF that a long while back had a little problem of keeping the engine, and firewall on the fuselage (hee heee, heeeee). Anyway, I reinforced the firewall at over twice the thickness that was stock, and reinforced areas on the front side the back sideof the firewall to the the fuselage. This time, it should hold.
The glue job of the ARF builder was not of the best, but then again, the YS 1.10FZ does have alot of power for this size of bird. I will still have to watch my stick movements for stress of the rest of the airframe, but I can hardly wait to hear the YS motor on by again.
Wow, what an engine!
Dennis
I have almost finished rebuilding the Spacewalker ARF that a long while back had a little problem of keeping the engine, and firewall on the fuselage (hee heee, heeeee). Anyway, I reinforced the firewall at over twice the thickness that was stock, and reinforced areas on the front side the back sideof the firewall to the the fuselage. This time, it should hold.
The glue job of the ARF builder was not of the best, but then again, the YS 1.10FZ does have alot of power for this size of bird. I will still have to watch my stick movements for stress of the rest of the airframe, but I can hardly wait to hear the YS motor on by again.
Wow, what an engine!
Dennis