Pizazz Thrust Line
09-25-2002 | 12:43 PM
#1
Thread Starter
My Feedback: (1)
Joined: Jul 2002
Posts: 1,820
Likes: 0
Received 0 Likes
on
0 Posts
From: gainesville, TX
Pizazz Thrust Line
I am slowing building(assembling) my H9 Pizazz. I am to the point where I am ready to install the engine. It is a Saito .72 with a 13 x 6.
Do I need any right, down, left, or up thrust in the engine?
Any suggestions?
Do I need any right, down, left, or up thrust in the engine?
Any suggestions?
09-25-2002 | 07:46 PM
#2
Senior Member
Joined: Dec 2001
Posts: 2,492
Likes: 0
Received 0 Likes
on
0 Posts
From: Castaic, CA
Pizazz Thrust Line
No down thrust but maybe some right thrust. I have maybe a half degree in mine and it acts like it could use a couple of degrees. My thumb says I'm holding a tad of right rudder a lot. I also have a slight warp in the wing so it's hard to tell.
Maybe some of the guys with straight ones can give you better insight.
Maybe some of the guys with straight ones can give you better insight.
09-27-2002 | 02:18 AM
#3
Member
Joined: Sep 2002
Posts: 49
Likes: 0
Received 0 Likes
on
0 Posts
From: Flint, MI
Pizazz Thrust Line
I had the same issue with my Pizazz as stock built. Then I read in one of the magazine reviews (rc report?) where the reviewer put in 5 degrees of right thrust. I compromized and put in 3 degrees with an OS 50SX, and found the plane tracks much better, especially on up/down lines and follows loops with very little rudder input.
