Hangar-9 f6f hellcat
06-03-2006, 09:11 PM
#1
Thread Starter
My Feedback: (2)
Join Date: Sep 2002
Location: millville,
UT
Posts: 1,434
Likes: 0
Received 0 Likes
on
0 Posts
Hangar-9 f6f hellcat
Could'nt resist it, just had to take it home. LHS owner says it was a Pre-release from a handful sent out to selected stores from H-9. Not bad at all, 'cept for the usual H-9 firewall problem. Very bad hit-and-miss with the ''hot glue ''on it. I can remedy that with short dowels and fiberglass resin. Looks pretty sturdy in the retract area, not bad at all. Wrong color on top of the horizontal stab though, that can be re-covered to the correct color. It's a -3 Hellcat type, We'll put a Saito .100 in it. Also a scale tailwheel, maybe Robart struts and painted brass tubes for the gun barrels. Might even go so far as to install a belly tank too. We'll stay in touch, MM
06-04-2006, 11:43 AM
#2
Thread Starter
My Feedback: (2)
Join Date: Sep 2002
Location: millville,
UT
Posts: 1,434
Likes: 0
Received 0 Likes
on
0 Posts
RE: Hangar-9 f6f hellcat
Well,....... this thread is rather boring, Let's wait for someone else to start this again and see if if it becomes interesting next time around. mm
06-04-2006, 05:11 PM
#3
Senior Member
Join Date: Nov 2005
Location: New York,
NY
Posts: 127
Likes: 0
Received 0 Likes
on
0 Posts
RE: Hangar-9 f6f hellcat
Add some pictures from your kit, and that will spice it up a a bit. Not many of us have one yet, so there's not much for us to say.
Cheerio
Cheerio
