GP GEE BEE Push-Rod Question ?
01-19-2008 | 07:01 AM
#1
Thread Starter
Senior Member
My Feedback: (2)
Joined: Jan 2002
Posts: 829
Likes: 0
Received 0 Likes
on
0 Posts
From: Iowa City IA
GP GEE BEE Push-Rod Question ?
Hi again, If I put the servos according to the instructions for the elevators and rudder (in the one tray) and
make sure the push-rods are exiting out of the correct holes the two
push-rods for the one side are not in-line when I try and put the
support braces in there to support the push rods. If I change the location
of the servos in that try the rods seem to be correct. Did anyone
else have this problem? Is it an error in the instructions?
Thanks,
Jeff
make sure the push-rods are exiting out of the correct holes the two
push-rods for the one side are not in-line when I try and put the
support braces in there to support the push rods. If I change the location
of the servos in that try the rods seem to be correct. Did anyone
else have this problem? Is it an error in the instructions?
Thanks,
Jeff
