topmodels cap232 3D
08-09-2006 | 11:49 AM
#2
Member
Joined: Apr 2005
Posts: 85
Likes: 0
Received 0 Likes
on
0 Posts
From: Wales, UNITED KINGDOM
RE: topmodels cap232 3D
A bit late posting this, but I've owned one for many years now and have a great performance and reliability from it. It was reported you can go down as low as a ZDZ40cc but although it will fly well (tried it), it is a little under powered on the vertrical. A 60cc would be much better. I've now installed a ZDZ80cc and is just awsome performance. Can't fault the model.
D.E.D.
D.E.D.
08-10-2006 | 12:08 AM
#3
Thread Starter
Senior Member
Joined: Jan 2003
Posts: 152
Likes: 0
Received 0 Likes
on
0 Posts
From: kinrooi, BELGIUM
RE: topmodels cap232 3D
I agree with you Dick, I've been flying this plane for more than 3 years now and powered with a 3W50 with tuned pipe it's a real hammer. Turns a 23/10 Mezljik at about 7000 RPM.
About the 3W50, I'm very satisfied about the perfomance but I had many starting problems with it. I'm using a DA50 in a Weiershauser Ultimate now (73inch) and man, what an engine !
Beats everything else I've owned so far. Relaible, much perfomance and very easy to start and tune. (See the picture of my new baby)
Thanks for your post.
About the 3W50, I'm very satisfied about the perfomance but I had many starting problems with it. I'm using a DA50 in a Weiershauser Ultimate now (73inch) and man, what an engine !
Beats everything else I've owned so far. Relaible, much perfomance and very easy to start and tune. (See the picture of my new baby)
Thanks for your post.
