Baby U-Can-Do-3D
06-05-2003 | 12:33 PM
#1
Thread Starter
My Feedback: (1)
Joined: Feb 2003
Posts: 57
Likes: 0
Received 0 Likes
on
0 Posts
From: Montgomery, AL
Baby U-Can-Do-3D
I just received a new UCD 46. I assume that it is from the first production run and I was a little concerned about that. However I am pleased to report that every piece in the box is flawless. I currently have two full size UCD's and the quality of the baby version seems as good or better at a glance. The cowl is especially nice compared to the big brother. The instructions recommend a .70 four stroke or .50 two stroke. I will use an OS .50 SX in mine. I'll post again after the first flight.
06-05-2003 | 02:33 PM
#3
My Feedback: (17)
Joined: Dec 2001
Posts: 485
Likes: 0
Received 0 Likes
on
0 Posts
From: Decatur, GA
Baby U-Can-Do-3D
Marc did a "weigh in" of this plane here in the 3D Forum. The all up weight minus engine and radio is 51.5 oz. Some "big items" where fuse + tail feathers at 19.2 oz, wing at 17.3 oz, and cowl at 2.1 oz.
Here's the link to the weigh in thread:
http://www.rcuniverse.com/showthread...64&forumid=230]
Here's the link to the weigh in thread:
http://www.rcuniverse.com/showthread...64&forumid=230]
