RCU Forums

RCU Forums (https://www.rcuniverse.com/forum/)
-   ARF or RTF (https://www.rcuniverse.com/forum/arf-rtf-75/)
-   -   World Models Ultimate 40 Bipe (https://www.rcuniverse.com/forum/arf-rtf-75/3064348-world-models-ultimate-40-bipe.html)

hrdrck551 02-12-2006 06:17 PM

RE: World Models Ultimate 40 Bipe
 
how much truth is there to the aileron servo, i have a hitech 645 for the aileron is this setup going to work for me?

HitecMan 02-12-2006 06:57 PM

RE: World Models Ultimate 40 Bipe
 
Ok guys I have a saito 72, do you think it could hove with it?

da Rock 02-12-2006 08:41 PM

RE: World Models Ultimate 40 Bipe
 

how much truth is there to the aileron servo, i have a hitech 645 for the aileron is this setup going to work for me?
The ailerons have very little chord. They only deflect about 10mm up and 10mm down. I use one standard servo and mine will roll very fast. I usually fly most of the flight with the dual rate switch for ailerons on low rate. If the HT645 is a standard, it'll do excellent.


Ok guys I have a saito 72, do you think it could hove with it?
It should climb out of sight, no problem. However, if by hovering, you mean hanging nose-up on the prop, that takes fairly large surfaces and the .46 Ultimate wasn't designed with those. My OS.46AX will pull it off the ground in a heartbeat and pull it out of sight, accelerating as it goes, but I've yet to be able to hold it steady, nose-up. I can land it at a walk, so the surfaces work well with airspeed and wind over them, but they're not big enough to do 3D stuff where the prop blast does the work.

HitecMan 02-12-2006 11:09 PM

RE: World Models Ultimate 40 Bipe
 
ok thaanks, is there a 46 size bipe ARF capable of 3-D

forestroke 02-13-2006 01:58 AM

RE: World Models Ultimate 40 Bipe
 
i think the only ones that are 3D bipes in that size are profiles


All times are GMT -8. The time now is 02:26 AM.


Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.