help kyosho cap 232 elevator
 

Need help on elevator system for my Cap: :confused:
Thanks
Grazie mille.

.
 

hi carletto, ya need to be a bit more specific if you can. lots of folks would be glad to answer any questions ya have.. :)

help kyosho cap 232 elevator
 

Thanks Tinman, i have more trouble with the balsa bar and the adj rod.
:confused:

help kyosho cap 232 elevator
 

Carletto,

On mine I have kept the balsa push rod and the 2mm Y push rod. I didn’t use the heat shrink, but instead bound he push rods with twine and then soaked the whole thing in CA. This has proved to give a very stiff Y connection. I did the same at the other end to the servo. I didn’t use the 90 degree bends to the servo arm replacing it with a clevis. I think that the 90 degree bend stuff in control links are weakening the push rod and can introduce slop.

Good luck

Kris