Nitro Edge 540T USA
 

I just started to put together my Edge 540T and I am finding out that the manual does not follow this plane at all times. I see that I was given an additional manual sheet but that only helped with the main wing. I need to know how I should handle putting in the servo and connecting the rudder. The manual shows that there is a small compartment under the fuselage near the tail. I do not see this compartment so I need to know what is the best way to connect this rudder?

RE: Nitro Edge 540T USA
 

Hold the plane up to the light. You will see the opening in the fus for the servo. Just trim it out & then hook up your linkage like you normally would . If it's a Nitro plane the instructions do leave a lot to be desired. Make sure you go over all glue joints you can reach & give them a drop of CA Good Luck

RE: Nitro Edge 540T USA
 

I just got mine and i really like it. Did u get your's in the air yet? If so how did it fly?

RE: Nitro Edge 540T USA
 

Take these questions to the NP support forum ( at the top of this forum ).