|
Top Cap with 50 SX Maiden!
1 Attachment(s)
Greetings,
One word: Woooooooow!!!!!!!!! funnyest plane I ever own!! Vertical with the 50 SX (12X4 prop with tuned pipe) is absolutely unlimited :eek: and that thing land almost in hovering. Knife edge is also very easy. Fun! fun! fun! Serge :D :D :D |
Top Cap with 50 SX Maiden!
Hey Serge,
My flying buddy has the exact same setup. He loves his too! I haven't flown it yet, but it looks like tons of fun! Mike |
Top Cap with 50 SX Maiden!
1 Attachment(s)
Hey Serge
I have the same set up.Fun plane. Doug |
rudder servos
Originally posted by stomper Hey Serge I have the same set up.Fun plane. Doug Doug, My top cat has some difficulty to hold knife edge loop. Can it be servo related?? I only have a futaba 3003 for the rudder. Do i kneed more torque to hold knife edge?? Thanks Serge |
Top Cap with 50 SX Maiden!
Serge
I have a JR 4721 at 120 oz on the rudder,so no problem here. The 3003 at 44 oz may not be enough to hold the plane. These planes really should have the elevator and rudder surfaces on a good ball bearing servos. This plane with a aft CG is a lot of fun to fly low and slow harrier figure eights just off the deck:) Doug |
Top Cap with 50 SX Maiden!
Originally posted by stomper Serge I have a JR 4721 at 120 oz on the rudder,so no problem here. The 3003 at 44 oz may not be enough to hold the plane. These planes really should have the elevator and rudder surfaces on a good ball bearing servos. This plane with a aft CG is a lot of fun to fly low and slow harrier figure eights just off the deck:) Doug Thanks Doug! I am gonna switch the rudder servo tonight. Serge :D |
| All times are GMT -8. The time now is 04:26 AM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.