RE: GSP <span class=
 

Sorry for such a newbie question... but can you elaborate on how you changed the incidence. did you just recut the holes for the alignment pins?

Oh and Cincinatti Joe: my cowling doesn't have any curling to it. I would contact the place you bought it from and exchange it

RE: GSP <span class=
 

Hello Graham,

Is this the 1.40 or the 80" Katana?
Thanks,

RE: GSP <span class=
 

Hi Wallbanger,
Sorry for the delay but we had our annual scale comp on the weekend and as I was CD they kept me busy.
Yes I just hacked away at the pin holes until I got a little positive incidence. It took about 1/4" slot to get it right.
If I had taken my time I could have adjusted the tail while building and had no problem at all.
Graybags,

Also F1race79

It is the 140 model.
In Australia they are marketed as CM Pro kits. You blokes get them as GSP I think. Same dog different leg action
Graybags.

RE: GSP <span class=
 

Graybags,

I have noticed a very disturbing problem with my model.. even with all the alignment pins I dont have one surface that incidence matches with any other [&o] . On top of that there is a definite mismatch within the horizontal stab and the wing [:@] Did you have the same problem while building this arf? I have so far just checked each surface to the others attempting to find some sort of zero as I do not have the engine mounted yet.