Different Servo's !!!!!!
10-21-2003 | 01:46 AM
#1
Thread Starter
Senior Member
Joined: Jul 2003
Posts: 648
Likes: 0
Received 0 Likes
on
0 Posts
From: UK
Different Servo's !!!!!!
Just a quick question........
Is it ok to use sawna servo's with a futaba reciever and radio ? IE : will the futaba extention leads etc work with the sawna servos ?
Thx
Is it ok to use sawna servo's with a futaba reciever and radio ? IE : will the futaba extention leads etc work with the sawna servos ?
Thx
10-21-2003 | 05:16 AM
#2
Senior Member
My Feedback: (1)
RE: Different Servo's !!!!!!
DragonHeart,
They will work with Futaba equipment as long as the wiring is correct. I not sure, but if I remember right, Sanwa servos may have been wired like older Airtronics servos. If so, you will need to reverse the positive and negative leads in the connector. Like I said, I'm not sure if this is the case. I think if the wire colors are red, black, black then it is Airtronics wiring. If so, reverse the black wire that would be in the middle with the red wire. You will also need to modify the connector if it is an Airtronics.
George
They will work with Futaba equipment as long as the wiring is correct. I not sure, but if I remember right, Sanwa servos may have been wired like older Airtronics servos. If so, you will need to reverse the positive and negative leads in the connector. Like I said, I'm not sure if this is the case. I think if the wire colors are red, black, black then it is Airtronics wiring. If so, reverse the black wire that would be in the middle with the red wire. You will also need to modify the connector if it is an Airtronics.
George
