To assemble my rascal 40 arf, I have everything but the dremel and drill bits. The manual mentions drilling holes from as low as 1/32 to 1/4 ". Home depot didnt have any less than 1/16. Where can I get a drill bit set for these sizes?
Do I get a manual drill or motorised drilling machine?
thanks!

Tower has a pin vise and bits.
$9.99
http://www2.towerhobbies.com/cgi-bin...?&I=LXL466&P=7

Hi JNorton, thanks but it doesnt seem to be less than 1/16 though...I think am confused not clear about the relation between the Drill#, Drill dia size etc...oh its confusing.

Here ya go
Decimal Equivalents
80...0.0135
79...0.0145
1/64 = .0156
78...0.0160
77...0.0180
76...0.0200
75...0.0210
74...0.0225
73...0.0240
72....0250
71....0260
70....0280
69....0292
68....0310
1/32 = .0312
67...0.0320
66...0.0330
65...0.0350
64...0.0360
63...0.0370
62...0.0380
61...0.0390
60...0.0400
59...0.0410
58...0.0420
57...0.0430
56...0.0465
3/64 = .0469
55...0.0520
54...0.0550
53...0.0595
1/16 = .0625
52...0.0635
51...0.0670
50...0.0700
49...0.0730
48...0.0760
5/64 = .0781
47...0.0785
46...0.0810
45...0.0820
44...0.0860
43...0.0890
42...0.0935
3/32 = .0937
41...0.0960
40...0.0980
39...0.0995
38...0.1015
37...0.1040
36...0.1065
7/64 = .1094
35...0.1100
34...0.1110
33...0.1130
32...0.1160
31...0.1200
1/8 = .1250
30...0.1285
29...0.1360
28...0.1405
9/64 = .1406
27...0.1440
26...0.1470
25...0.1495
24...0.1520
23...0.1540
5/32 = .1562
22...0.1570
21...0.1590
20...0.1610
19...0.1660
18...0.1695
11/64 = .1719
17...0.1720
16...0.1770
15...0.1800
14...0.1820
13...0.1850
3/16 = .1875
12...0.1890
11...0.1910
10...0.1935
9...0.1960
8...0.1990
7...0.2010
13/64 = .2031
6...0.2040
5...0.2055
4...0.2090
3...0.2130
7/32 = .2187
2...0.2210
1...0.2280