I have 2 Old Radio Control Sets, Model FP-T6FN (S/N's 90702014 and 80705340). They are frequencies 72.160 MHz and 72.240 MHz. I would like to get the transmitters and receivers updated (I have been told I cannot use these frequencies any longer). Also, if possible, I was hoping to have these checked for the batteries, etc..

Please let me know how to proceed and thank you in advance for your help!


Mike

Check on Futaba's website www.futaba.com they have a page where they list what radios can be updated. They're on 72 mhz so changing frequencies can still be done, Futaba will have to change the TX crystal but you can do the receiver.

Andy

Thanks for your reply! I went to the Futaba site and sent an email to check if they can retrofit. Hope it works out.

Again, thanks for your help!

Mike
[sm=biggrin.gif]

I was wondering the same thing about 2 months ago. If I read the Futaba web site correctly, the answer you will get from them is no.