Hi all

I know this had been asked before but can't seem to find the answer via search so.....

I was doing the elevator hinges on my 4*60 and the covering has fogged slightly where the hinges are. I may have been a bit sloppy with my application of the CA [:@] What is the best way to clean the covering?

Thanks
Vaughan

I use a little debonder on a paper towel.
But not to much.Seems to work ok.

I did the same on my LT-40 build a few days ago... gotta hit the LHS for some CA debonder as well.

somegeek

Acetone works very well too.

Thanks guys, nitro works as CA de-bonder doesn't it?