LT-40 CG location
02-17-2003 | 03:20 AM
#1
Thread Starter
Junior Member
Joined: Aug 2002
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
From: Ballston Lake, NY
LT-40 CG location
My friend is refurbing an old LT-40.
Without a drawing or manual he needs the design
CG location... inches behind the leading edge.
I would appreciate any help
Ed Buell
Without a drawing or manual he needs the design
CG location... inches behind the leading edge.
I would appreciate any help
Ed Buell
02-17-2003 | 03:35 AM
#2
Member
Joined: Jan 2003
Posts: 73
Likes: 0
Received 0 Likes
on
0 Posts
From: Beaumont, TX
LT-40 CG location
Hey Ed,
"aerobat66 [C.G.] 3.5" - 4.25" behind leading edge of wing. Mine flew it's maiden flight yesterday, with the C.G. at about 4", and it was fine. I had about 3/4" of elevator throw (manual recommends 9/16"), and it was fairly pitch sensitive."
This is from a previous post from aerobat66 about the same question on the lt-40. Hope this helps
"aerobat66 [C.G.] 3.5" - 4.25" behind leading edge of wing. Mine flew it's maiden flight yesterday, with the C.G. at about 4", and it was fine. I had about 3/4" of elevator throw (manual recommends 9/16"), and it was fairly pitch sensitive."
This is from a previous post from aerobat66 about the same question on the lt-40. Hope this helps
