Suggestions for installing FlyLite Light Tubes
#1
Thread Starter
Join Date: Nov 2005
Location: Poolesville, MD
Posts: 12,624
Likes: 0
Received 0 Likes
on
0 Posts
Suggestions for installing FlyLite Light Tubes
Anyone have any suggestions about affixing Tower's FlyLite Light Tubes to wings and fuselage surfaces?
I've tried Blemderm but I'm not too happy with the results.
I'm thinking of cutting a groove and epoxying the lights in place.... but I was looking for any suggestions from anyone who has affixed these lights onto their planes.
Thanks.
I've tried Blemderm but I'm not too happy with the results.
I'm thinking of cutting a groove and epoxying the lights in place.... but I was looking for any suggestions from anyone who has affixed these lights onto their planes.
Thanks.
#3
Thread Starter
Join Date: Nov 2005
Location: Poolesville, MD
Posts: 12,624
Likes: 0
Received 0 Likes
on
0 Posts
RE: Suggestions for installing FlyLite Light Tubes
Sure thanks...
[link=http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXMPN3]Blue Tubes[/link]
[link=http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXSGB1]Red Tubes[/link]
[link=http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXMPN3]Blue Tubes[/link]
[link=http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXSGB1]Red Tubes[/link]
#4
RCU Forum Manager/Admin
My Feedback: (9)
RE: Suggestions for installing FlyLite Light Tubes
Bruce,
Do a search on Tower's site using the "light tube" as the search terms.
Here are the results of that search.
[link]http://www3.towerhobbies.com/cgi-bin/WTI0095P?FVSEARCH=light+tube&search=Go[/link]
Ken
Do a search on Tower's site using the "light tube" as the search terms.
Here are the results of that search.
[link]http://www3.towerhobbies.com/cgi-bin/WTI0095P?FVSEARCH=light+tube&search=Go[/link]
Ken
#7
Thread Starter
Join Date: Nov 2005
Location: Poolesville, MD
Posts: 12,624
Likes: 0
Received 0 Likes
on
0 Posts
RE: Suggestions for installing FlyLite Light Tubes
ORIGINAL: Knight_74
I have similar lights that I got from Varad a few years ago. I just used clear radio box tape to hold them down on a zagi.
I have similar lights that I got from Varad a few years ago. I just used clear radio box tape to hold them down on a zagi.
RTV or silicon adhesive with the groove may be viable to give a fairly clean look.