Charging Airtronics TX
#53
Thread Starter
Senior Member
Gimmie the address and I'll ship em right in.
Going to see if I can do a range check with the RDS8000 today. The Big Bingo is coming along very good. I hope it is a good flyer. Lots of control surfaces, esp. rudder and elevator. I have a Magnum 180 4 stroke on it. Calls for up to 160 so I don't think I am too far out of the range. It uses exactly the same wing as my SeaMaster 120 of course both models were made by Ace. Only 7* this morning as I type this. We have about 14-16" on the ground. 0 wind this morning.

Going to see if I can do a range check with the RDS8000 today. The Big Bingo is coming along very good. I hope it is a good flyer. Lots of control surfaces, esp. rudder and elevator. I have a Magnum 180 4 stroke on it. Calls for up to 160 so I don't think I am too far out of the range. It uses exactly the same wing as my SeaMaster 120 of course both models were made by Ace. Only 7* this morning as I type this. We have about 14-16" on the ground. 0 wind this morning.
#54

My Feedback: (1)
Yeah, if you have any issues, it would probably be CG. And that, most likely will be a minor fix (setting that is). Hope it flys good for you.
We had some snow overnight, only about an inch or so. We're expecting more this afternoon, perhaps another two or so inches. Oddly, enough, more in the southern part of the state than the northern part, but this is fairly typical. We will see what we get tonite.
Dick.
We had some snow overnight, only about an inch or so. We're expecting more this afternoon, perhaps another two or so inches. Oddly, enough, more in the southern part of the state than the northern part, but this is fairly typical. We will see what we get tonite.
Dick.



