fule Refilling system with Cowling
 

Hi Friends,

I have assembled the Harrier 90 3d and dont know where to leave fule refilling tube?

please suggest :-)


Regards
Sidharth

RE: fule Refilling system with Cowling
 

look into a three line fuel tank and fuel dot

RE: fule Refilling system with Cowling
 

Ditto

If you don't have a 3-line tank already and you don't want to take it all apart, DuBro has a new refueler that I have used several times that works well. I don't like most fuel valves but I have had very good luck with this one:

http://www3.towerhobbies.com/cgi-bin...?&I=LXWDG9&P=7

RE: fule Refilling system with Cowling
 

where ? i can't see

RE: fule Refilling system with Cowling
 

I take the tank, and install kind of the opposite of a vent line. A brass line that goes to the floor, and rear of the tank. I fill, and empty through that line...by means of a dot.

This way my carb line doesn't need any attention. The muffler pressure line I splice, and leave a little long so I can fish it out the bottom of the cowl and disconnect, so I know when the tanks full

RE: fule Refilling system with Cowling
 

Hi Minn Flyer

I have tank with 3 tubings 1goes into enngine carb,1goes into exaust cylencer, one is for taank refelling <ABOUT THIS i have the ruestion , where i should hang this:-) ?

thanks

RE: fule Refilling system with Cowling
 

Pick up a Fuel Dot.

Mount it in a convenient place on your cowl

RE: fule Refilling system with Cowling
 

<font size="2" color="#00265e">MinnFlyer</font>  thanks