set time on 4 stroke
 

need to set time on 4 stroke

RE: set time on 4 stroke
 

Need more information on the ENGINE;)

RE: set time on 4 stroke
 

its a os 61 had to take cam out lifters stuck bad got the values working now but got to put back in time seene dot on cam but can not see dot on crank thanks butch

RE: set time on 4 stroke
 

http://www.osengines.com/manuals/

see if you can find your model listed and download the manual

unless this is the same one

http://www.rcuniverse.com/forum/m_25...tm.htm#2515075

RE: set time on 4 stroke
 

it just says find mark on cam and crank line them up but on 4stroke with cam out crank looks like worm gear no mark thanks butch

RE: set time on 4 stroke
 

If memory serves me correctly all you do is put the piston at top dead center then install the cam so that the dot lines up with the pushrod tubes.

RE: set time on 4 stroke
 

thank you alot

RE: set time on 4 stroke
 

You don't need to have the piston and rod installed. There is a timing mark on the thrust washer that has to be facing up and even with the casting mark. Now slide the cam in with the dot facing straight down at 6 oclock. Print out the file and tack it on your shop wall.;)

RE: set time on 4 stroke
 

WTG GB!

RE: set time on 4 stroke
 

I have been using this little book and telling folks about it for years. I bought it years ago when I sent in an OS .70 for service to tower. They told me they would test run it and let me know what was wrong before they did anything to it. I was sure it was the needle valve, I had flown the plane through a tree and the engine wouldn't run after that. Tower took it apart, let me know it was run lean, had bent parts and was going to cost me a couple bucks less then a new engine to have it repaired. I had them send it back to me, it was in the box but taken apart. Bought the book, assembled the engine and it still wasn't running correctly. Replaced the needle valv assembly and ran the engine inverted in a IMAA plane for three years without a dead stick. Last engine I ever sent in for repairs.
The book may still be printed?? A GUIDE TO OS 4 STROKES By Graham C. Rice and sold through the RCM Anthology Library?? It used to be sold in most hobby shops for just a couple bucks. You don't see a lot of Gudgeon Pins in newer engines but other then that it's still everything you need to know about most 4 strokes.