Programming a Futaba 9C (PCM) for dual elevator servos
 

I'm new to all this and need some info on programming my elevator, it uses one servo on each side so I assume I have to use two channels but how are they programmed on the 9C.
Help will be greatly appreciated.

Programming a Futaba 9C (PCM) for dual elevator servos
 

Wa8,

I set up my plane with two elevator servos. You have to set up the Ailevator function and use channels 1 and six (or is it 2 and six) I'll have to check my plane. It is on page 49 of your manual.... if you have it. If not, let me know and I can fax it.

I found this on Futaba's web site....

http://www.futaba-rc.com/faq/faq-9c-q512.html

Programming a Futaba 9C (PCM) for dual elevator servos
 

Hi wa, do a search in the radio manufacturer's forum (Futaba) and you'll find this fully covered and more. I think there's some issue on the frame rate as well that might interest you. Good luck.........

Programming a Futaba 9C (PCM) for dual elevator servos
 

The Ailevator function uses channels 2 and 8. If you are using a 7 channel receiver, you need to mix 2 and (5 or 7)