contrler
 

i have the regular control for parkzone. When i do full blast it wont work but, if i back off a little bit it will work why does it do this? Are all the stuff not plugged in all the way or what?

RE: contrler
 

You might have a problem with the speed controller. Full power might be drawing too much current from the battery and causing the electronic speed controller to cut out.

If your Parkzone plane is fairly new, you should contact the manufacturer for warranty service.

RE: contrler
 

it does the same thing on both battery and when i first got it dident do that

RE: contrler
 

Could be you full blasted it into a bad Tx connection?...Rog

RE: contrler
 

Right, that would be consistent with a speed controller problem. The Electronic Speed Controller (ESC) connects to the battery, the motor, and the receiver. It governs the speed of the motor by regulating how much juice goes to it based on input from the throttle control on your transmitter.

On some park flyers, the ESC and receiver can be combined onto a little controller board.

It sounds like you're having problems with that particular component in your Parkzone airplane.

RE: contrler
 

yeah because i duno what happen but i did this barrow roll and after that all the power went out and sometimes when i connect the battery i have to put it a certain way or it wont work