Brushless motor
#1
Thread Starter
Join Date: Dec 2014
Posts: 20
Likes: 0
Received 0 Likes
on
0 Posts
Brushless motor
I noticed this morning after a flight, when turning the engine on the stand, that the propeller moved forward by at least 1/4". Is it normal for the rotating housing to act like that? I broke the shaft last week and I installed the propeller the other end.
I found the answer. There is a retaining lock washer on the shaft, I lost it when the shaft broke. No place to install another one, also the engine is scraped!
I found the answer. There is a retaining lock washer on the shaft, I lost it when the shaft broke. No place to install another one, also the engine is scraped!
Last edited by Volo; 02-23-2015 at 10:44 AM.