Program ECS help
I need help with a Thunderbird 9 speed control, brushless. The motor would not run at full throttle only 1/2 throttle so I though I would re program it. BIG MISTAKE. Now it will not enter the program mode and will not recognize the 3 Li-Pol cell. It only continally beeps what Castle calls "the first multi tone ring"
OK I am a newbie but need help. Thanks Stan |
RE: Program ECS help
[8D]I have not heard of a thunderbird 9 speed control, but you did mention castle.
Is it one of theres ? What are you using for control? Computer radio, standard, three or four channel. If it continualy beeps, the controler probably isn't even. getting a signal. What current are you drawing, motor and prop combo? need more info! |
RE: Program ECS help
It is a Castle Creations new item Thunderbird 9 brushless controller.
I am using a Futaba Skysport 4 channel radio I really do not know what current is being drawn Motor is a Himax brushless outrunner hc 2808-0980. If I can not save this esc I will purchase another perhaps you can suggest. I am just dying to get this plane up Thank you for your support |
RE: Program ECS help
What prop and batt. are you using? You should be able to get the USB cable to program it with your computer.
|
RE: Program ECS help
The service people at Castle Creations sent me the secret.
SL |
RE: Program ECS help
woww, i was looking for the answer cause i am having the same problem but nobody want give me the secret....
That would have been so nice TO GET IT FROM YOU. THANKS |
All times are GMT -8. The time now is 05:55 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.