RCU Forums - wrong programer on thunderbird esc

RCU Forums (https://www.rcuniverse.com/forum/)

- Brushed/Brushless motors, speed controls, gear drives (https://www.rcuniverse.com/forum/brushed-brushless-motors-speed-controls-gear-drives-123/)

- - wrong programer on thunderbird esc (https://www.rcuniverse.com/forum/brushed-brushless-motors-speed-controls-gear-drives-123/7118720-wrong-programer-thunderbird-esc.html)

tdriver

02-22-2008 02:31 PM

wrong programer on thunderbird esc

I accidently put my thunderbird-18 in a different programmer, by the time i found that out,
the programmer-display was stuck at "reading"
now the esc does not work nor does it make any beep sounds when connecting the battery.
it only put the right voltage out for the receiver.

my question is:
will castle link re-program the esc? or should i buy a new thunderbird insted of castle link?

cyclops2

02-22-2008 05:23 PM

RE: wrong programer on thunderbird esc

E-mail Castle. Save time & the warrenty.

Rich

tdriver

03-08-2008 04:42 PM

RE: wrong programer on thunderbird esc

i did a firmware upgrade,but now it sucks at the start up sequense playing the melody over and over.....ordered a new one....

All times are GMT -8. The time now is 12:08 PM.