Modified Nitro Engines
#1
Senior Member
Thread Starter
Join Date: Feb 2004
Location: Canton, OH
Posts: 169
Likes: 0
Received 0 Likes
on
0 Posts
Modified Nitro Engines
Not sure what forum this goes in, but anyways. I was curious as to if you could use, say a .26 sleeve inside the S-25. But of course some minor mods would be necessary or atleast it seems it would too me.
anyway ever wondered this or tried it?
anyway ever wondered this or tried it?
#2
Senior Member
Join Date: Mar 2004
Location: san fransisco, CA,
Posts: 104
Likes: 0
Received 0 Likes
on
0 Posts
RE: Modified Nitro Engines
Ive tried it on my buddys and it worked for a little and then he drove it off a ramp into the lake 2min after.
So im guessing if you put all the other parts neccessary also the it also might work ( MY HYPOTHOSIS )
So im guessing if you put all the other parts neccessary also the it also might work ( MY HYPOTHOSIS )
#3
Senior Member
My Feedback: (1)
Join Date: Feb 2004
Location: Richmond,
VA
Posts: 4,000
Likes: 0
Received 0 Likes
on
0 Posts
RE: Modified Nitro Engines
ORIGINAL: crazypyro013
Not sure what forum this goes in, but anyways. I was curious as to if you could use, say a .26 sleeve inside the S-25. But of course some minor mods would be necessary or atleast it seems it would too me.
anyway ever wondered this or tried it?
Not sure what forum this goes in, but anyways. I was curious as to if you could use, say a .26 sleeve inside the S-25. But of course some minor mods would be necessary or atleast it seems it would too me.
anyway ever wondered this or tried it?
#5
Senior Member
Thread Starter
Join Date: Feb 2004
Location: Canton, OH
Posts: 169
Likes: 0
Received 0 Likes
on
0 Posts
RE: Modified Nitro Engines
ORIGINAL: tegwin
The extra compression would proberably bend the con rod or crack the casing on the 25 engine
The extra compression would proberably bend the con rod or crack the casing on the 25 engine
i figured that much...
i was just a tid bit curious about doing that, i guess i'll try it on my old .15fe engine, i'll try swapping a .18 sleeve and piston and rod, and all that great stuff.... when its finished i shall report back about it
#6
Member
Join Date: Oct 2010
Location: , NS, CANADA
Posts: 40
Likes: 0
Received 0 Likes
on
0 Posts
RE: Modified Nitro Engines
Sounds kind of crazy but what the hell. Good luck crazy RC character!
ORIGINAL: crazypyro013
Not sure what forum this goes in, but anyways. I was curious as to if you could use, say a .26 sleeve inside the S-25. But of course some minor mods would be necessary or atleast it seems it would too me.
anyway ever wondered this or tried it?
Not sure what forum this goes in, but anyways. I was curious as to if you could use, say a .26 sleeve inside the S-25. But of course some minor mods would be necessary or atleast it seems it would too me.
anyway ever wondered this or tried it?