Pass the pipe
11-20-2007 | 02:49 AM
#1
Thread Starter
Senior Member
Joined: May 2007
Posts: 352
Likes: 0
Received 0 Likes
on
0 Posts
From: so cal,
CA
Pass the pipe
With the new mill I've bought...(OS28XZ)...I've noticed that the JP-3 that I run is good threw the more technical parts of our track...I noticed that I can keep the engine on the pipe as they say....But I can tell that this pipe is like....it's kinda hard to say in words.... holding this mill back ...for a lack of better words..."LOL" ...if thats what I'm trying to say..there's really not any holding back this mill but I know there's more there.....any thoughts on what pipe would be good on this mill...I just having trouble parting with a $140.00 on an OS 2060 when I know there is something out there just as good for a little less...."LOL"....not that I'm cheap but dam thats a lot of scratch for a pipe....thanks...[8D]
11-21-2007 | 03:43 AM
#3
Thread Starter
Senior Member
Joined: May 2007
Posts: 352
Likes: 0
Received 0 Likes
on
0 Posts
From: so cal,
CA
RE: Pass the pipe
Hey thanks I'll give that pipe a try.....and thanks for the reply......you figure all these self profess engine guru there be more then just one reply....I guess I'm not in the circle...LOL .....Like someone posted a few days ago...I guess everybody runs TT- ST-1 and LRP's with JP-3 now....."LOL"...so why ask anything of any value...."LOL"....oh thats right I didn't put in that the JP-3 is the best pipe in the world and every other pipe that you guys run sucks....my bad...."LOL"...
11-21-2007 | 08:43 PM
#5
Senior Member
Joined: Jun 2007
Posts: 682
Likes: 0
Received 0 Likes
on
0 Posts
From: Gold CoastQueensland, AUSTRALIA
RE: Pass the pipe
Iam running the thunder tiger long pipe 2035 and manifold on an os 28 mainly because it was cheap and i read a good review in a mag on the pipe (was running on a lrp spec 3 28). I havent tried another pipe as yet so i cant offer any other comments.
