RCU Forums - Using non-pullstart mounts on a pullstart engine

RCU Forums (https://www.rcuniverse.com/forum/)

- Car Nitro & Gas Engines (https://www.rcuniverse.com/forum/car-nitro-gas-engines-269/)

- - Using non-pullstart mounts on a pullstart engine (https://www.rcuniverse.com/forum/car-nitro-gas-engines-269/2475971-using-non-pullstart-mounts-pullstart-engine.html)

lateapex

12-28-2004 11:02 AM

Using non-pullstart mounts on a pullstart engine

OK, I have a pullstart Nova Rossi CX12 in a RC10GT. I bought a starter box for it so I need to bring the flywheel down. I have some non-pullstart mounts that I can use but the side of the engine gets in the way. If I grind away the material thats in the way on the mount, it will pretty much split it in two. Will this be OK or should I look for a different mount?

I'll try to post some pics later.

Carnutz68

12-28-2004 01:18 PM

RE: Using non-pullstart mounts on a pullstart engine

Yea pics might help us, sometimes i cut the chassis out enough so the starter wheel will fit...:D:D:D

lateapex

12-29-2004 06:04 PM

RE: Using non-pullstart mounts on a pullstart engine

its cool, I just wound up cutting the engine mount and it fits now. :)

Carnutz68

12-29-2004 07:34 PM

RE: Using non-pullstart mounts on a pullstart engine

Good job, glad it worked....:D:D:D

All times are GMT -8. The time now is 07:01 PM.