CT4-S Engine Questions
07-24-2004 | 11:26 PM
#1
Thread Starter
Senior Member
Joined: Nov 2002
Posts: 1,129
Likes: 0
Received 0 Likes
on
0 Posts
From: Wood River,
IL
CT4-S Engine Questions
I broke the pull-start on my CT4 on the second tank 
So, I took the pull-start off and to my suprise the pull start shaft is being suspended by a bushing instead of a bearing. My question is what size bearing would I need to replace it?
Also, I am not going to be using a pull-start on this engine any more(getting starter box). Could I cut off the pull-start shaft to reduce rotational mass in the engine?
So, I took the pull-start off and to my suprise the pull start shaft is being suspended by a bushing instead of a bearing. My question is what size bearing would I need to replace it? Also, I am not going to be using a pull-start on this engine any more(getting starter box). Could I cut off the pull-start shaft to reduce rotational mass in the engine?
