Hi,

I ran my MT2 into curb, it broke its universal swing shaft. I fixed the universal swing shaft, and noticed that there was clicking sound when I used my steering. I opened up steering servo, and its smaller gear was missing 3 teeth. Is there any way of fixing it? (Its a CEN servo). Anyways, for the time being, I bought a cheap servo to fit in my throttle servo (low torque) and I put the rear (hi torque) original CEN servo in steering. But now my steering is not showing full left/right turns.

What could be the reason?

1. Does the rear CEN servo doesnt have original power as stereing CEN servo?
2. Is there some settign wrong in the wheels that I am not able to turn properly?? ( I oopened it up to replace universal swing shaft.)

Thanks for helping..

I am a beginner with R/C

The stock steering servo was the first thing I broke. They are pretty cheap. Your best bet is to buy a Hitech HS-645mg. You can get them new off Ebay for under $40 and they turn the wheels better than the stock servo. Look at item 6007194452 on Ebay. $38 dollars after shipping if you use the 'Buy Now' (I like the buy now items as I don't like to wait, or bid in the last 5 minutes).