NX .26 carb
#1
Senior Member
Thread Starter
Join Date: Apr 2005
Location: Charlottesville,
VA
Posts: 5,253
Likes: 0
Received 0 Likes
on
0 Posts
NX .26 carb
Is it an Aluminium or Nylon carb?
Does it have a 15mm mount?
What's the bore, 8 or 9mm?
Does it have carb inserts?
Well..... that's it.
Does it have a 15mm mount?
What's the bore, 8 or 9mm?
Does it have carb inserts?
Well..... that's it.
#3
Senior Member
Thread Starter
Join Date: Apr 2005
Location: Charlottesville,
VA
Posts: 5,253
Likes: 0
Received 0 Likes
on
0 Posts
RE: NX .26 carb
So it's much like the Nova nd RB Nylon carbs then I guess?
From what I can see it's a 3 needle carb. It is hard to tune it and where is a good setting for the midrange needle?
I'm thinking about picking one up and try it.
From what I can see it's a 3 needle carb. It is hard to tune it and where is a good setting for the midrange needle?
I'm thinking about picking one up and try it.
#4
Senior Member
Join Date: Dec 2005
Location: Newville, PA
Posts: 142
Likes: 0
Received 0 Likes
on
0 Posts
RE: NX .26 carb
I can't answer any tuning qustions for you. Mine ran away on the last breakin tank and broke the connecting rod s I bought a .28 for in it.
It worked pretty good throughout breakin though.
It worked pretty good throughout breakin though.
#5
Senior Member
Join Date: Apr 2003
Location: City of Industry,
CA
Posts: 1,516
Likes: 0
Received 0 Likes
on
0 Posts
RE: NX .26 carb
Here is the factory recommended setting. We usually just leave the mid-range at flush.
Top- 3 turns out
Mid- Flush
Bottom – 4 turns in
Top- 3 turns out
Mid- Flush
Bottom – 4 turns in
#6
Senior Member
Thread Starter
Join Date: Apr 2005
Location: Charlottesville,
VA
Posts: 5,253
Likes: 0
Received 0 Likes
on
0 Posts
RE: NX .26 carb
Cool! Thanks.
The neck is a few mm longer than the carb I am replacing so I'll just need to trim it on a lathe or something.
The neck is a few mm longer than the carb I am replacing so I'll just need to trim it on a lathe or something.