I recently upgrade my magnum nx to steel gears, today while driving, I kept throwing the left rear dog bone. I was checking it after putting it back together and there seems to be a lot of slop compared to the others when installed, any suggestions on how to remedy this?

Hey there, You could try cutting a piece of fuel line tubing and putting it inside the outdrives to take up some slack. I have done this and found it to work. Good Luck

I tightened up the wheel hub and it seems to have taken care of the problem.

Yes- simply tighten the pillow balls (evenly) and that will draw the bone deeper into the cup!
Let us know if you have any further concerns: [email protected]