Default position for 2nd and 3rd gear adjustment screws
Can anyone out there suggest a good starting point for the 2nd and 3rd gear adjustment scews? I called CEN and the tech said that 2nd should be 2.5 turns out from bottom and 3rd should be 3.5. This cant be right because this causes the screws to bind on the housing. I'm hoping to revert the shift points without pulling the tranny. Thanks...
|
RE: Default position for 2nd and 3rd gear adjustment screws
I was told 7 turns out for the 3rd gear clutch.
|
RE: Default position for 2nd and 3rd gear adjustment screws
Are you refering to full turns or 1/8 turns? If you are refering to full turns, I don't think that is correct. The scews are binding on the housing at around 3 full turns.
|
RE: Default position for 2nd and 3rd gear adjustment screws
sorry, must of read it wrong
|
RE: Default position for 2nd and 3rd gear adjustment screws
no need to apologize. I feel like at one time the CEN shift adjustment document had the default positions. however it currently does not. maybe CEN can shed some light.
|
RE: Default position for 2nd and 3rd gear adjustment screws
You must be talking about the set screws
and not the adjustment screws The set screws need to be done with the gearbox stripped down the adjustment screws are the ones that are set at an angle not the screws facing straight out The adjustment for second gear is 5 full turns out Third gear is 7 to 7.5 full turns out hope this helps |
RE: Default position for 2nd and 3rd gear adjustment screws
Now I get it. I'm an idiot. Now that I have totally screwed up the set screws, Any suggestions for getting them back to where they need to be with out pulling the tranny and clutch?
|
RE: Default position for 2nd and 3rd gear adjustment screws
ORIGINAL: sparky 25 The adjustment for second gear is 5 full turns out Third gear is 7 to 7.5 full turns out hope this helps |
RE: Default position for 2nd and 3rd gear adjustment screws
ORIGINAL: lambo77 ORIGINAL: sparky 25 The adjustment for second gear is 5 full turns out Third gear is 7 to 7.5 full turns out hope this helps http://www.rcuniverse.com/forum/m_7426307/tm.htm |
All times are GMT -8. The time now is 04:24 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.