Good evening fellows, needs some info. I picked up a very nice Aurora 60 about 6 months ago and just finished the radio installation. I have several YS motors I could used but I'm waiting on Richard Verano for the new YS motor. In the mean time, I need to know where the CG location is. This plane is the PA-2, Phillips Aircraft clone on the MK kit, very hard to tell from the original. Who ever built this plane really new what they were doing, very well thought out construction. I've checked thru various post here and I see someone said "205"mm,
8.05" from the leading edge. Can anyone verify this for me? - thanks, Steven

To compare:
On MK Aurora 60 the center of gravity is from leading edge 166.0 millimeter / 6.535 inch.
I have the MK Aurora 60 plan (also digitally) so I just checked this.
If You want to have the whole plan to ckeck againt Your Aurora You can PM me.

/Bo

Bo, thank you very much. I was hoping the answer I would receive would come from MK plans. I had the suspision that 8.00 inches was to much. Reviewing these plans brings back the memory of 6 to 6.5 inches.
thanks again Bo, really appreciate it.
Regards, Steven