Found what I needed.
04-03-2007 | 03:54 PM
#1
Thread Starter
Member
Joined: Apr 2007
Posts: 66
Likes: 0
Received 0 Likes
on
0 Posts
From: RR#4 Aylmer,
ON, CANADA
Found what I needed.
Hi guys,I recently purchased a OS 1.40RX engine and it came with the OS header and what I was noticing is that the engines exhaust port opening is bigger than the headers inlet.My question,is there a reason for this.I am a mechanic and have hopped up alot of engines and we allways match up the headers to the exhaust ports,so I don't know if the same rules apply to these engines.One more question what would be the best pipe to use to get the most power at the highest rpms,not worrying about noise regulations.
04-03-2007 | 04:16 PM
#2
Senior Member
My Feedback: (1)
Joined: Oct 2002
Posts: 2,707
Likes: 0
Received 0 Likes
on
0 Posts
From: Woodstock, GA
RE: OS 1.40RX-P Header
They don't.
never heard of a "P" before.
but just use that header, it doesn't care....trust me, I've run 12 of them into the dirt.
-Mike
never heard of a "P" before.
but just use that header, it doesn't care....trust me, I've run 12 of them into the dirt.
-Mike
