OS & YS Engine Manuals...
#1
Thread Starter
My Feedback: (18)
Join Date: Feb 2003
Location: Euharlee,
GA
Posts: 1,828
Likes: 0
Received 0 Likes
on
0 Posts
OS & YS Engine Manuals...
Here is my collection of OS and YS engine manuals...I use to have them uploaded to a free hosting website but it's gone down the tubes...I wasn't aware you could upload PDF files here...This will be much better...
Some of these are kinda big files so they may take a while to load on slower networks..
You can use Adobe reader to view them which you can get from here:
http://www.adobe.com/products/reader/
To save to your computer just click the little floppy disk lookin' thingy in the upper left corner of the window (next to the printer lookin' thingy)...
We'll start with the Hanno Manual (good tuning info), Hanno RCM Review and OS horsepower ratings:
Some of these are kinda big files so they may take a while to load on slower networks..
You can use Adobe reader to view them which you can get from here:
http://www.adobe.com/products/reader/
To save to your computer just click the little floppy disk lookin' thingy in the upper left corner of the window (next to the printer lookin' thingy)...
We'll start with the Hanno Manual (good tuning info), Hanno RCM Review and OS horsepower ratings:
#3
Thread Starter
My Feedback: (18)
Join Date: Feb 2003
Location: Euharlee,
GA
Posts: 1,828
Likes: 0
Received 0 Likes
on
0 Posts
RE: OS & YS Engine Manuals...
OS 61 RF manual, OS 61 SF manual, OS Type 86 carburetor, PA-102 pump instructions, OS Pumps pre-2000-pump-carb-instructions, OS Drill Template ***Be sure and set the view to 100% before re-producing***..
#5
Thread Starter
My Feedback: (18)
Join Date: Feb 2003
Location: Euharlee,
GA
Posts: 1,828
Likes: 0
Received 0 Likes
on
0 Posts
RE: OS & YS Engine Manuals...
YS 45 FS/FR manual, YS 60 FS/FR manual, YS 61R-LS manual, YS 61R-AR manual...
**Notice: Adobe Reader may have to install Japanese fonts to view correctly**...
**Notice: Adobe Reader may have to install Japanese fonts to view correctly**...
#8
Senior Member
Join Date: Nov 2003
Location: corona del mar,
CA
Posts: 118
Likes: 0
Received 0 Likes
on
0 Posts
RE: OS & YS Engine Manuals...
Some of these manuals may look familliar to you since many of them (the good ones) were written by Clarence Lee. Clarance, is without a doubt, the most knowledgeable engine man ever, and is still sitting on a backlog of manuals that he has been contracted to write. He is also one of the finest people to ever flip a prop and I cherish every moment I have been able to spend with him.
Scott
Scott
#9
Junior Member
My Feedback: (10)
Join Date: Dec 2007
Location: Broomfield, CO
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
I would like to say : many many many Thanks to Mr: Chuck has post those manuals for us. I Recently obtain this used engine without any documentation & manuals and
I almost give up to find manual for this engine and seem nobody can help until I found this post.
Again Thanks a lot sir.!
Hung Ta
I almost give up to find manual for this engine and seem nobody can help until I found this post.
Again Thanks a lot sir.!
Hung Ta