|
RE: Super Sceptor
The elevator servo was in a tray and off center. I used a fiberglass arrow shaft for elevator and rudder push rods. The exhause extension was a thin wall silicon tube that attached to the end of the pipe stinger and went between the pushrods. Did not use the PP. When I started it looked really tight, but as it went along, everything fell into place and worked quite well. If you need a sketch of the upped deck attachment method, let me know.
|
RE: Super Sceptor
.
|
RE: Super Sceptor
ORIGINAL: Dave Harmon It was always a honest airplane and truthfully, I haven't liked but just a couple of airplanes as well in the 23 years since. Ditto. Just can't remember what I did with mine. BTY-beautiful paint scheme. |
RE: Super Sceptor
Dave,
Check your PM's. Doug |
RE: Super Sceptor
.
|
| All times are GMT -8. The time now is 03:44 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.