Vess Prop Delamination
04-29-2013, 06:41 AM
#1
Thread Starter
My Feedback: (80)
Join Date: Aug 2008
Location: clute, TX
Posts: 141
Likes: 0
Received 0 Likes
on
0 Posts
Vess Prop Delamination
Just wondering if anyone else has experienced this before? Over the weekend I maidened a 37.5% Pilot yak powered by an old blue head 3W 150. Just a 5 min test flight for trim and settings, no hard maneuvers or 3d as it was the maiden. Afterwords I was shocked to see the prop was broken at the laminating point. It looks as though it just let go at the seam, cant imagine if this would have happened in a 3d routine! Never seen this before with any manufacturer, just wondering how often this occurs?
04-29-2013, 09:35 AM
#6
Thread Starter
My Feedback: (80)
Join Date: Aug 2008
Location: clute, TX
Posts: 141
Likes: 0
Received 0 Likes
on
0 Posts
RE: Vess Prop Delamination
Just talked to Vess, offered to replace at no cost, thats customer support! Still the question is how often does this happen, with any brand prop?
