zaggi xt converting to brushless
03-22-2004 | 08:19 PM
#1
Thread Starter
Junior Member
My Feedback: (2)
Joined: Jul 2003
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
From: savage ,
MN
zaggi xt converting to brushless
H i have owned a xt for a while and it is too slow does anyone know what brushless motors I could use that would keep the cost low and the speed high
03-24-2004 | 09:06 PM
#2
Senior Member
Joined: Jan 2002
Posts: 396
Likes: 0
Received 0 Likes
on
0 Posts
From: Glen Carbon, IL
RE: zaggi xt converting to brushless
Look at a Himaxx brushless from http://www.allerc.com these are probably the most reasonible priced brushless motors.
You might try a http://www.hobbypeople.net/gallery/131480.asp cobalt motor, the price is great, you can probably use you existing
speed control and battery and this will be a big upgrade over stock! Use a 6x4 E prop instead of the usual 5x5. I have an EdgeRC Overlord wing and nobody with a Speed 400 can keep up.
The least expensive brushless combo would be a Himaxx with a Phoenix brushless controller about $130.
You must use a brushless esc with a brushless motor!!
Good Luck
You might try a http://www.hobbypeople.net/gallery/131480.asp cobalt motor, the price is great, you can probably use you existing
speed control and battery and this will be a big upgrade over stock! Use a 6x4 E prop instead of the usual 5x5. I have an EdgeRC Overlord wing and nobody with a Speed 400 can keep up.
The least expensive brushless combo would be a Himaxx with a Phoenix brushless controller about $130.
You must use a brushless esc with a brushless motor!!
Good Luck
