VNR3d with blade stuff
03-15-2007 | 04:03 PM
#1
Thread Starter
Senior Member
Joined: Jan 2006
Posts: 802
Likes: 0
Received 0 Likes
on
0 Posts
From: Colorado Springs,
CO
VNR3d with blade stuff
I want to put a HH gyro on my VNR3d, but the only way to do that is to replace the tx and the 4n1 with something else, and I was looking at the 3n1/tx/rx combo used on the blade cp pro. Is it really plug and play with a HH gyro? If it is, then what gyro would you recomend, and how would it be hooked up? Thanks in advance for the info. Peace.
