factory settings help
03-22-2007 | 01:22 PM
#1
Thread Starter
Junior Member
Joined: Jan 2006
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
From: citrus heights,
CA
factory settings help
Ok so i got my blade cp a couple months ago...my brother flew it first for 10mins,when i wasnt around, then crashed it, sighhh, sp i never saw it fly. i tried replacing the blades and it would barely lift off ground, then i realized i got the symmetrical blades, very new to heli, so i finally got a pair of plastic blades, but my brother screwed with EVERYTHING trying to get it to work.
Is there a guide to reset everything to how it comes out of box? or at least to optimal settings? otherwise im doing all kinds of things and not really learning what does what. thanks.
Remember im new to Heli, but not to RC, been in nitro car/trucks for awhile.
Is there a guide to reset everything to how it comes out of box? or at least to optimal settings? otherwise im doing all kinds of things and not really learning what does what. thanks.
Remember im new to Heli, but not to RC, been in nitro car/trucks for awhile.
03-22-2007 | 02:20 PM
#2
Senior Member
Joined: Sep 2003
Posts: 1,148
Likes: 0
Received 0 Likes
on
0 Posts
From: Hunlock Creek,
PA
RE: factory settings help
Visit
www.bladecprepair.com
You will get great starting points. Most importantly, check blade pitch, swash level & height, and paddle pitch. That ought to get you in the ballpark.
Jim
www.bladecprepair.com
You will get great starting points. Most importantly, check blade pitch, swash level & height, and paddle pitch. That ought to get you in the ballpark.
Jim
