esc programming help
 

I just went brushless and I am having problems programming the ESC. It says full throttle up , then plug in battery and you should hear a beep. then 5 seconds later another beep... but that never happens.. the three and one just flashes and never makes a beep. Help!

RE: esc programming help
 

What type of esc, motor and radio?

RE: esc programming help
 

eflite as recomended in the manual..

RE: esc programming help
 

Hmmmmmmmm.

Make sure both the "Y" harness for power and "Y" harness for the servos are connected properly.

Should hear some sort of beep. If not, could have gotten a bad esc.

RE: esc programming help
 

it beeps once as I hook to batttery.. Eflite says it(ESC) is factory set "lipo on, brake off" which is what we want. so i bypass set up.... So then I pull stick down and hook to battery and wait for 3 in1 to initialize, but nothing happens. It beeps once then red blinks as normal but doesn't go green, just red and green. (((( 3 leads from motor to esc, lead from esc red wire pulled, plug into y harness, throttle lead from 3 in1 into other end of y harness, plugged harness into # 3, battery lead to 3in1, last lead into battery)))

RE: esc programming help
 

I'm stumped.

RE: esc programming help
 

Check if your throttle channel is reversed.

RE: esc programming help
 

BBCCONT, you da man! That was it ! thanks>>