Question about my CP Pro
 

I just purchased a CP Pro (used, two actually) and have begun playing around with it/them a bit. Anyway, on one of them, the rudder is reversed. If I push left, the tail swings right and vice versa. The other works as it should and uses the same radio. I will admit that I am a rookie. My only previous experience with heli's (or anything RC'd for that matter) is my Blade CX2. Thanks in advance.

Aaron

RE: Question about my CP Pro
 

look at the radio, there are four switches at the bottom right corner one of them is labeled rud( the fourth switch) these are servo reverse, on mine the switched are set: ail= nor, ele=rev, thr=nor, RUD= rev. check and see how yours are set. my rudder was normal when I bought it I reversed it so the controls were the same as my CX2.

hope that helps!!!:D

RE: Question about my CP Pro
 

I will chech it when I get home from work. Thanks!

RE: Question about my CP Pro
 

your welcome!!!:D