alloy main frame.
 

Hi.
I've just got an alloy main frame http://www.ushobbysupply.com/product...roducts_id=530 bit confused as the screws supplied are not all correct. That problem I can get round.
What I would like to know is there are 3 brass washers, but nowhere for them to go. The check list shows them, but the instruction sheet doesnt.
Any idea where they go.?
Im wondering if they should go on the underside of the mainframe on the 3 screws securing the main tower shaft, or between the baseplate and the main tower shaft.

Any help would be great .
Thanks.

RE: alloy main frame.
 

Phil,
i had one of those frames and I cannot tell you why they would supply the washers. I didn't have any with mine. I will say, however, this doesnt fit a CX. it's for a CX2 only. Although, with a few minor mods, I got it to work fine on my cx. Hope it helps a lil bit.
quattro

RE: alloy main frame.
 

Thanks for the info quattro1975

It is for a CX2 so no worries there.

More spares for my screw pot.:D

RE: alloy main frame.
 

Hi Phill86, i used mine on the servos when screwing to the maine frame .