Programming a JETI ESC with the Program card
 

Hello guys,

i got a new Advance 12 Plus + program card, and im trying to program it. i set all the jumpers, connected the ESC on one side and then connected a 4 cell Nimh pack (4.8V) on the other side (the manual calls for a 4-6V source) and im waiting for the beep im supposed to hear but nothing happens !!

any idea what am i doing wrong ? battery polarity is correct and battery is charged, but no beeps.
thanks.

RE: Programming a JETI ESC with the Program card
 

Did you turn on the switch for the ESC? No beep unless you power up the system.

RE: Programming a JETI ESC with the Program card
 

There is no switch in this ESC, just a battery plug in, which i thought i shouldnt do, since im using a 4.8V source for the program card, no ?

RE: Programming a JETI ESC with the Program card
 

Unless it is an Opto ESC, you don't use the receiver battery but rather plug a flight pack into the main power wires.

Be sure that the motor is connected to the ESC to hear the beep. It happens about 1 second (or less) after connecting battery power.

Only use the 4-cell receiver battery connections on the upper left part of the card with OPTO-isolated Jeti Advance PLUS ESCs.

Good luck!

RE: Programming a JETI ESC with the Program card
 

It works !! thanks a lot man !!