RCU Forums - Problem with MicroDan 2510 3d

RCU Forums (https://www.rcuniverse.com/forum/)

- Electric General Discussion (https://www.rcuniverse.com/forum/electric-general-discussion-106/)

- - Problem with MicroDan 2510 3d (https://www.rcuniverse.com/forum/electric-general-discussion-106/9719873-problem-microdan-2510-3d.html)

extreme911

05-08-2010 04:33 PM

Problem with MicroDan 2510 3d

Hello everyone,

i just connected my MicroDan (for the first time) to ESC and its looks like the motor not working properly... please see this videohttp://xtactics.com/P10100782.wmv
I was trying to swap cables.. but the result is always the same...
Please help! What i did wrong?

Walt Thyng

05-08-2010 05:33 PM

RE: Problem with MicroDan 2510 3d

Can't tell much from th video. Are you using a Futaba TX? If so reverse the throttle channel.
Walt

extreme911

05-08-2010 06:12 PM

RE: Problem with MicroDan 2510 3d

im using Spectrum dx6i

DaveFlynn

05-08-2010 08:11 PM

RE: Problem with MicroDan 2510 3d

Check the motor with an ohm meter. You might have an open or shorted winding.

All times are GMT -8. The time now is 09:29 PM.