Go Back  RCU Forums > Electric Aircraft Universe > Electric General Discussion
 Problem with MicroDan 2510 3d >

Problem with MicroDan 2510 3d

Community
Search
Notices
Electric General Discussion General Discussion forum about rc electric related aircraft, accessories, flight, tips, etc.

Problem with MicroDan 2510 3d

Thread Tools
 
Search this Thread
 
Old 05-08-2010 | 04:33 PM
  #1  
Thread Starter
Junior Member
 
Joined: May 2010
Posts: 2
Likes: 0
Received 0 Likes on 0 Posts
From: , ON, CANADA
Default Problem with MicroDan 2510 3d

Hello everyone,

i just connected my MicroDan (for the first time) to ESC and its looks like the motor not working properly... please see this videohttp://xtactics.com/P10100782.wmv
I was trying to swap cables.. but the result is always the same...
Please help! What i did wrong?
Old 05-08-2010 | 05:33 PM
  #2  
My Feedback: (9)
 
Joined: Jul 2002
Posts: 1,874
Likes: 0
Received 0 Likes on 0 Posts
From: St. Charles, IL
Default RE: Problem with MicroDan 2510 3d

Can't tell much from th video. Are you using a Futaba TX? If so reverse the throttle channel.
Walt
Old 05-08-2010 | 06:12 PM
  #3  
Thread Starter
Junior Member
 
Joined: May 2010
Posts: 2
Likes: 0
Received 0 Likes on 0 Posts
From: , ON, CANADA
Default RE: Problem with MicroDan 2510 3d

im using Spectrum dx6i
Old 05-08-2010 | 08:11 PM
  #4  
Senior Member
 
Joined: Feb 2007
Posts: 450
Likes: 0
Received 0 Likes on 0 Posts
From: Arcadia, CA
Default RE: Problem with MicroDan 2510 3d

Check the motor with an ohm meter. You might have an open or shorted winding.

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are On



Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.